R440 2/3-axis problem

[Aeryn]

Hi!

When I change the R440 to 2 axis movement in the device settings, the cursor starts centered, but when I hit the gas pedal the axis moves down and stays there (see pic: http://members.a1.net/taranga/r440.JPG), but its supposed to move to the center again ;)

I used the pedals some time as rudder pedals in flightsims, worked fine.
But when I added/removed some usb devices this 2axis movement doesn't work anymore, the axis stays at the bottom.

3axis movement works fine for both pedals so I dont think its a hardware problem.

thx

[tige]

I have exactly the same problem. Running an X52 along with the R440 as pedals. I did have it running but had to do a re-install and since then it doesn't recognise the two axis when selecting 'operate pedals seperately'.

any assistance would be appreciated as its driving me nuts.....

[UKSupport]

Hi,

This is addressed on the support page for the wheel on our website under Q4. Download that calibration utility, run it and then restart the PC. When you get back into Windows, the pedals should be working fine.

[tige]

thanks for the reply, I will d/l and see how it goes.

*** :) working fine now, again thanks very much ***

[Schwips2006]

Hello

I trying to download that "calibration utility" , but the file cannot be found at ftp server , how i can fiind this?

[UKSupport]

Hi,

Give it another try - it should be fine now.

[Schwips2006]

Thank's :o